Equipment does not operate ?
- Equipment is not ‘on’ position. Bring in to ‘on’
- No voltage. Check the plug.
- Plug / Cable failure. Call the technical service.
- Engine failure. Call the technicl service.
- Failure of On-Off button. Call the technical service.
- Failure of circuits. Call the technical service.
Equipment stops frequently during the cutting operation ?
- Insufficient voltage. Check the voltage and compare it with the value given in the operating manual.
- Failure of circuits. Call the technical service.
Gear rotates, but does not cut ?
- Knife broken or blunt. Call the technical service.
Gear rotates, but slips ?
- Gear might have been covered by food material. Remove any food material on the gear.
- Gear teeth broken. Call the technical service.
Engine runs, but gear does not rotate ?
- Internal failure. Call the technical service.
Equipment stops after a short time ?
- Insufficient ventilation. Make sure the ventilation grilles are not obstructed.
- Excessive power. Call the technical service.
